Dot Hill Systems RAIDCore Manuel d'utilisateur télécharger pdf (Page 29)

The array is critical and the re-inserted drive is shown in the Disk List. To rebuild the array first click on

the array in the Array list to highlight it. Next, right click on the re-inserted disk in the Disk List. This will

bring up the options screen that will allow you to assign the disk as either a Global or Dedicated spare.

Select one of the spare options then click on OK. The rebuild will start within a few seconds.

When the rebuild begins there will be a pop-up indicating that the rebuild task has resumed. The

messages always say resumed regardless of if the rebuild is being initiated for the first time or being

resumed after being paused by command or a rescan operation.

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 38 39

Pas de commentaire

Dot Hill Systems RAIDCore Manuel d'utilisateur Page 29