Dot Hill Systems RAIDCore Manuel d'utilisateur télécharger pdf (Page 23)

Section 3: Using the RAIDCore Management Software

How to replace a failed drive in a RAID 1 array:

Note: This procedure only applies when there is no I/O from the time the failed disk was removed to the

time the new disk was inserted.

Physically remove the failed hard drive from the machine. The RAIDConsole will display a pop-up

indicating that a drive was removed and a rescan is required. The rescan will remove the drive from the

configuration. Click on RESCAN.

After the Rescan completes you will see the RAID-1 array as critical in the array view, you will also see

that the pulled drive was removed from the disk list.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 38 39

Pas de commentaire

Dot Hill Systems RAIDCore Manuel d'utilisateur Page 23